The original oil filler plug must be replaced with direct knife. Please note that the probe is often wetted with geschleudertem oil. Therefore, a measurement on, for example, the oil drain plug results in a different value.
Danger Please carefully compare the thread diameter, pitch and length of the oil dipstick with the replacement part !!!!!!!!
Dimensions: - thread x pitch: 24 x 3.0 mm - Thread length: 11 mm - Total needle length: 89 mm - Exposed needle length: 69 mm
No reason for complaint The bubble in the sight glass assures the compensation of the damping oil when heated!
- Produced by BorgWarner Morse - in original equipment quality - for direct riveting on the vehicle, please use our open control chains with enclosed lock
- Made in Japan - Chain pins made of carburizing vanadium
The chain pins of these DID control chains are by a special surface treatment hardened and allow up to three times longer service life than conventional control chains
- Produced by BorgWarner Morse - in original equipment quality
CONTROL CHAIN ​​LOCKERS FOR BORG WARNER AND DID ARE ALSO AVAILABLE SEPARATELY. DO NOT USE ANY BRANDS, BUT ONLY THE CONTROL CHAIN ​​FOR THE BRANCH!
Installation: Open the old control chain and connect it to the new control chain, and then rivet a new control chain. To save you several hours of work, since the engine does not have to be disassembled completely.
- Made in Japan - Chain pins made of carburizing vanadium
The chain pins of these DID control chains are by a special surface treatment hardened and allow up to three times longer service life than conventional control chains
- PLEASE DO NOT USE THE BRANDS OF THE BRACKET FOR THE BRANCHES ONLY!
Installation: Simply open the old control chain and connect it to the new control chain, pull through and then rivet the new control chain. This saves you several hours of work, since the engine does not have to be disassembled completely.