Innovative quick-release screw for the safe, clean and fast venting and filling of hydraulic brakes and clutches on all motor vehicles. Single hand operation without external help.
Also particularly suitable for the exchange of rubber against steel flex cables.
CNC precision nickel-plated brass for replacement against conventional venting nipples.
Colored cap is not included in the scope of delivery - can be ordered as an accessory.
Price Unit: 1 Unit
for Honda XRV 750 Africa Twin RD07 1993-2003 front rear
Brake discs EBC. MADE IN UK. The aim of the development is to improve the braking performance compared to the original brake disc. EBC uses low carbon HPSR steel, which has an 18% higher coefficient of friction. This steel is much more resistant to rust than cast steel. In addition, the entire surface is protected by a 3 micron thick zinc layer, which abrades itself in the area of ​​the brake pad contact zone during braking. Only in this area can more easily rust form during prolonged life.
The brake discs are drilled in Vogelschwingendesign to get along with as few holes as possible while optimizing cleaning of the brake disc of rainwater and brake dust. The fewer holes are fitted, the better the wet braking performance and the lower the wear.
- Rigid brake disc. - Made from rolled low carbon HPSR steel. - Drilled brake surface with optimized hole pattern. - Radially ground. - Galvanized for protection against corrosion. - EBC recommends EBC Organic Brake Pads or for sporty drivers EBC Double-H Sintered Brake Pads. - Independent design.
Price Unit: 1 Unit
for Honda XRV 750 Africa Twin RD07 1993-2003 front
EBC MX brake disc for offroad motorcycles. MADE IN UK.
The aim of the development is to improve the braking behavior compared to the original brake disc. EBC uses HPSR steel with a low carbon content, which has an 18% higher friction coefficient. This steel is significantly more resistant to rust than cast steel. In addition, the entire surface is protected by a 3 micron thick zinc layer, which is already abraded in the area of ​​the brake lining contact zone when braking. It is only in this area that it is easier to form rust rust with a longer service life.
The brake discs are drilled in the bird's swing signal to get rid of the rainwater and brake dust with as few holes as possible while simultaneously cleaning the brake disc. The less drill holes are installed, the better the wet braking behavior and the lower the wear.
- Rigid brake disc. - Made from heat-treated carbon steel. - Braked surface with optimized hole pattern. - Radially ground. - Galvanized for protection against corrosion. - EBC recommends EBC Organic TT brake pads or for sporty drivers EBC sintered brake blocks in R or MXS mixture. - Stand-alone design. - The thickness of the brake disc may vary from the original part.
Contents: 2 sets of SBS 694HS brake pads for left and right
The perfect combination for an optimum of fading-free braking performance, brake feel and heat stability, specially developed for sports and heavy use of heavy motorcycles.
The HS
- Off-road brake pads with high-quality semi-organic mixture - Good durability under dry weather conditions - Very well dosed pads with low thermal load - Ideal for vehicles that tend to squeal - Perfect friction adjustment on the Ec'o Offroad brake discs - For vehicles with road registration an ABE is available
Price Unit: 1 Set
for Honda XRV 750 Africa Twin RD07 1993-2003 front
SH coating mixture Full metal sintering surface with special finish. High friction coefficient, guarantees very good performance. Can be used on almost all discs. Only in exchange for sintered linings in the original equipment. Only conditionally applicable in racing, since no heat resistance from 400 degrees. The friction coefficient is adjusted to the SV surface. Only for rear axle use.